top of page
prodotti-texa-RC3-top.jpg

RC3

Rev counter and scan tool

RC3'ü keşfedin
Rev counter and scan tool
prodotti-texa-RC3-prod.jpg
prod-g-rc3-03.jpg

RC3

TEXA’s revolutionary RC3 not only keeps engine RPM and temperature under constant control but also serves as an ECU scanning tool. It therefore allows mechanics to perform two types of test using just the one tool.

The RC3 (Revolution Counter 3) interface can read data in three different ways: using an induction clamp with piezoelectric sensors, using a microphone with the residual battery signal, or directly from the OBD socket (on vehicles with the necessary protocol).


When plugged into the OBD socket to measure engine RPM and temperature, RC3 reads data directly using EOBD protocol, so there is not even any need to open the bonnet.


RC3 can also be used in scan-tool mode; connected to the EOBD socket, it can read the parameters defined by this standard in accordance with new emission control procedures.

Technical Specifications

PROCESSOR SYSTEM
MB90F591 16MHz

 

SERIAL RESOURCES
1 1.1 USB Connection
1 RS232 standard connection

 

EXTERNAL POWER SUPPLY
8 ÷ 32 Volt

 

WIRELESS CONNECTION
1.2 Bluetooth technology

 

PETROL AND DIESEL DETECTION FROM VEHICLE BATTERY
12VDC and 24VDC Systems management

 

PETROL ANALOGUE DETECTION
Induction pincers

DIESEL ANALOGUE DETECTION
Piezoelectric sensor

 

EOBD DETECTION
ISO9141-2; ISO14230; SAE J1850 PWM; SAE J1850 VPW; CAN ISO11898

 

ENVIRONMENTAL
Operating temperature: -5°C ÷ +40°C
Operating moisture: 10% ÷ 80% without condensation
Storage temperature: -20°C ÷ +60°C

 

DIMENSIONS
155x162x63 mm

 

WEIGHT
800 g

GALERİ
bottom of page